11/26/2022 0 Comments Cisco asa 5505 port forwarding![]() ![]() Your static translation is translating port 21 from the outside interface IP to port 21 on an IP that is not on any network that appears in the rest of your config: 172.16.1.214 Most clients use passive FTP just fine which will negotiate things differently and not use the data port. You do also need to add another access-list line for ftp data according to the doc that erratick linked but I've never had to do that to make things work. The access list looks at traffic as it hits the interface on which it is applied so in this case you need it to allow traffic destined for the IP address of the outside inteface (since that is where you are forwarding port 21 from). The access-list for allowing FTP should look like this:Īccess-list outside_access_in extended permit tcp any interface outside eq ftp Are you changing the config before posting (to obfuscate your IP)? Or is that line for line copy and paste? He has inspect ftp already it looks like.Įldersoul, your access-list and static translation are inconsistent. Policy-map type inspect dns preset_dns_map ![]() Snmp-server enable traps snmp authentication linkup linkdown coldstartĬrypto ipsec transform-set ESP-3DES-MD5 esp-3des esp-md5-hmacĬrypto map outside_map 1 match address outside_1_cryptomapĬrypto map outside_map 1 set peer 199.227.180.130Ĭrypto map outside_map 1 set transform-set ESP-3DES-MD5Ĭrypto map inside_map 1 match address outside_cryptomap_1Ĭrypto map inside_map 1 set peer 199.227.180.130Ĭrypto map inside_map 1 set transform-set ESP-3DES-MD5ĭhcpd address 192.168.1.4-192.168.1.254 inside Static (inside,outside) tcp interface ftp 172.16.1.214 ftp netmask 255.255.255.255Īccess-group outside_access_in in interface outside Nat (inside) 0 access-list inside_nat0_outbound Icmp unreachable rate-limit 1 burst-size 1 Please help!Įnable password lCrzpddxiv3Ah07a encrypted I have followed every discussion I could find and as best as I can tell, things are set up as they should be. Snmp-server enable traps snmp authentication linkup linkdown coldstartĭhcpd address 192.168.1.2-192.168.1.I think I am losing my mind. Timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute Static (outside,inside) tcp 192.168.1.2 https 0.0.0.0 https netmask 255.255.255.255Īccess-group outside_access_in in interface outside ** I am strictly using ASDM to connect to ASA device.Īccess-list outside_access_in extended permit tcp any eq https host A.B.C.D eq https <= the public ip is A.B.C.D I have tried to configure (1) the Access Rule and (2) NAT using ASDMĭestination=a.b.c.d (which is a public IP)Įnable PAT, protocol is TCP, original and destination port is https * 1 Public IP Address (obatined using DHCP) I am trying to setup simple port forwarding from public IP address (outside VLAN) to the SBS 2003 (inside VLAN). I need to update Access List and NAT using ASDM. This is pretty simple, but I just cant figure it out. This has been asked before - but the steps outlined in other posts cant seem to make my setup work. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |